Art Gallery
Specials . Quick Tips . Techniques .

Art Gallery


Karalee Ingram - Idaho

Karalee Ingram - Idaho
Upload Date : Fri 19 Oct 2012 05:40:56 PM CDT
Stamp Credits : Large Poinsettia 3695-475N,
Spirit of Christmas Set 3694-475G
or from Holiday Foliage Stamp Set 475
Other Supplies : 1/8 inch double sided Tear-ific tape SAT02
VersaMark Pad 99702
Embossing powder in Gold EP169 &
Gold Detail EP168
Sparkling Snow Glitter G1003
Sakura Glue Pen 99202
Copic markers
Detail scissors
Cardstock in: Black, White, Pearlized Cream
Detail scissors
1-1/2 inch wide oval die or punch
Fine point black marker
Paper cutter
Instructions : Finished card is 5 x 7 inches
1) Cut Black cs to 5 x 7 inches.
2) On white cs with VersaMark pad, stamp
Poinsettia. Sprinkle with Gold ep and heat set.
Color with Copics and fussy cut.
3) Cut 3 pillars from pearlized cream cs at
1-1/2 inches wide. Cut one pillar at 3 inches,
one at 4 inches, and one at 5 inches.
4) Die cut 3 ovals. Adhere each oval to
the tops of each pillar. Now arrange and
adhere the candle pillars together, making
sure they are even on the bottom and no
wider than the Poinsettia cutout. Using
black fine point marker, define the outlines
of the 2 smaller pillars by following the
outside edge where one lies on top of the other.
5) Adhere Poinsettia to front of pillars.
Center and adhere this to front of black
card front.
6) With VersaMark, stamp greeting in
upper left corner on black card front. Sprinkle
with Gold Detail ep and heat set.
7) Die cut 3 more oval from white cs. Place
the top of the die about 2/3ís of the way down
the original cut oval. These will be the candle
flames. Color with Copics and adhere with glue
over the top of each pillar as shown.
8) Use fine point black marker to hand draw candle
wick an each pillar.
9) Using glue pen, go around the outside of each
flame, in the center of each flame and at the base
of each wick. Sprinkle with Sparkling Snow glitter.
Tap off excess.
10) Adhere card front to card base.


Featured Card . Customer Comments .